This picture is looking at the manifold end has a 60mm inlet ID and a 3 bolt flange where the outlet end has a 2 bolt flange and a 50mm outlet ID. Increasing your engine’s torque output gives you the power you need to haul heavy payloads and tow trailers, boats, campers, and more. The Carven-TR Series Performance Muffler delivers a deeper sound with a lower tone. Bradley’s Auto Service is proud to be affiliated with TechNet, a network of more than 12,000 locally owned repair shops that are focused on delivering quality care to the communities they serve. When you have any kind of automotive work done by us or another TechNet-affiliated shop, you are covered nationwide.
An upstream air injection point, ahead of the catalytic converter, is also sometimes present to provide additional oxygen only during the engine warm up period. This causes unburned fuel to ignite in the exhaust tract, thereby preventing it reaching the catalytic converter at all. This technique reduces the engine runtime needed for the catalytic converter to reach its "light-off" or operating temperature. Many vehicles have a close-coupled catalytic converter located near the engine's exhaust manifold. The converter heats up quickly, due to its exposure to the very hot exhaust gases, enabling it to reduce undesirable emissions during the engine warm-up period.
The first widespread introduction of catalytic converters was in the United States automobile market. The exhaust system is crucial to a car’s performance, especially the catalytic converter which can go bad if it’s overworked. A stock exhaust system strives to minimize the car’s materials while maximizing space. This means that the exhaust system’s performance can suffer, having to work harder with less horsepower.
Walker is your one-stop exhaust shop, offering a full line of mufflers, pipes, hardware and accessories. Cat to Y pipe intersection showing after cat O2 sensor location. This qualifies as one of the STRANGEST stock exhaust parts I have seen. For some reason Toyota/Lexus decided to weld a straight section of 60mm pipe to the cat outlet flange, angle cut it, weld a 50mm pipe pipe that has its last couple of inches expanded to 60mm and match angle cut. Also note the O2 placement is in the 50mm sections of the Y pipe where the sensor tip takes up a good portion of the available flow area.
Choose ARK and you will not be disappointed with the sound and quality of our products. Installing a catback exhaust system is a relatively easy task. However, it is important to follow the instructions that come with the system. If you are not comfortable installing the system yourself, you can take it to a qualified mechanic. Get an exclusive inside look at what we are doing on a daily basis with Banks’ Insider News.
Shopping for